1. Using a level or other leveling device, mark a line to install and level the starter strip.

2. It is crucial that the starter strip is level and all corners match to ensure the proper alignment of all subsequent courses of siding.

3. Attach the BEAR CLIPs to the top edge of the starter strip as you nail it.

4. Once the starter strip is up and level, and the BEAR CLIPs are in place, you are ready to install the first course.

5. Place the first board into the BEAR CLIPs you attached to the starter strip.

6. As you nail the board to the substrate, attach 3 BEAR CLIPs per 12 foot board along the top edge of the board you are nailing. (Use 4 clips when applying boards wider than 8¼")

7. Install subsequent courses in the same manner.

8. Using the tool provided, (Clip Removal Tool-CRT) insert the tool into the hole on the BEAR CLIP.

9. With a quick motion apply downward force to the tool breaking off the BEAR CLIP at the engineered fracture point.
 

Bear Cub Industries, LLC. produces the Bear Clip™ for a specific intended use. Please refer to the provided instructions for the intended use thereof. Bear Cub Industries, LLC. accepts no liability due to misuse. Any liability due to proper use is limited only to the cost of the product. The siding has to be secured at all times; standard safety rules for installation apply. Do not leave lap board unsecured in clip. Bear Clips are used as spacers only, not to secure the lap board to the substrate.

© 2007 James Hardie International Finance B.V. All rights reserved. TM, SM, and ® denote trademarks or registered trademarks of James Hardie International Finance B.V. is a registered trademark of James Hardie International Finance B.V.